7-溴-8-甲基喹啉 | 809248-61-1

• 物质功能分类: 医药中间体 - 杂环化合物 - 喹啉类化合物
• 分子结构分类: 有机化合物 - 有机杂环化合物 - 喹啉及其衍生物
• 中文名称: 7-溴-8-甲基喹啉
• 英文名称: 7-bromo-8-methylquinoline
• CAS: 809248-61-1
• 化学式: C₁₀H₈BrN
• 分子量: 222.084
• InChiKey: MLTSRPXEANUCKX-UHFFFAOYSA-N

物化性质

• 熔点：
  47-48.5 °C
• 沸点：
  312.7±22.0 °C(Predicted)
• 密度：
  1.488
• 溶解度：
  甲醇（微溶）、乙酸乙酯（微溶）

计算性质

• 辛醇/水分配系数(LogP)：
  3.2
• 重原子数：
  12
• 可旋转键数：
  0
• 环数：
  2.0
• sp3杂化的碳原子比例：
  0.1
• 拓扑面积：
  12.9
• 氢给体数：
  0
• 氢受体数：
  1

安全信息

• 海关编码：
  2933499090
• 危险性防范说明：
  P261,P305+P351+P338
• 危险性描述：
  H315,H319,H335
• 储存条件：
  室温

SDS

Material Safety Data Sheet

---

Section 1. Identification of the substance
Product Name: 7-Bromo-8-methylquinoline
Synonyms:

---

Section 2. Hazards identification
Harmful by inhalation, in contact with skin, and if swallowed.

---

Section 3. Composition/information on ingredients.
Ingredient name: 7-Bromo-8-methylquinoline
CAS number: 809248-61-1

---

Section 4. First aid measures
Skin contact: Immediately wash skin with copious amounts of water for at least 15 minutes while removing
contaminated clothing and shoes. If irritation persists, seek medical attention.
Eye contact: Immediately wash skin with copious amounts of water for at least 15 minutes. Assure adequate
flushing of the eyes by separating the eyelids with fingers. If irritation persists, seek medical
attention.
Inhalation: Remove to fresh air. In severe cases or if symptoms persist, seek medical attention.
Ingestion: Wash out mouth with copious amounts of water for at least 15 minutes. Seek medical attention.

---

Section 5. Fire fighting measures
In the event of a fire involving this material, alone or in combination with other materials, use dry
powder or carbon dioxide extinguishers. Protective clothing and self-contained breathing apparatus
should be worn.

---

Section 6. Accidental release measures
Personal precautions: Wear suitable personal protective equipment which performs satisfactorily and meets local/state/national
standards.
Respiratory precaution: Wear approved mask/respirator
Hand precaution: Wear suitable gloves/gauntlets
Skin protection: Wear suitable protective clothing
Eye protection: Wear suitable eye protection
Methods for cleaning up: Mix with sand or similar inert absorbent material, sweep up and keep in a tightly closed container
for disposal. See section 12.
Environmental precautions: Do not allow material to enter drains or water courses.

---

Section 7. Handling and storage
Handling: This product should be handled only by, or under the close supervision of, those properly qualified
in the handling and use of potentially hazardous chemicals, who should take into account the fire,
health and chemical hazard data given on this sheet.
Store in closed vessels.
Storage:

---

Section 8. Exposure Controls / Personal protection
Engineering Controls: Use only in a chemical fume hood.
Personal protective equipment: Wear laboratory clothing, chemical-resistant gloves and safety goggles.
General hydiene measures: Wash thoroughly after handling. Wash contaminated clothing before reuse.

---

Section 9. Physical and chemical properties
Appearance: Not specified
Boiling point: No data
No data
Melting point:
Flash point: No data
Density: No data
Molecular formula: C10H8BrN
Molecular weight: 222.1

---

Section 10. Stability and reactivity
Conditions to avoid: Heat, flames and sparks.
Materials to avoid: Oxidizing agents.
Possible hazardous combustion products: Carbon monoxide, nitrogen oxides, hydrogen bromide.

---

Section 11. Toxicological information
No data.

---

Section 12. Ecological information
No data.

---

Section 13. Disposal consideration
Arrange disposal as special waste, by licensed disposal company, in consultation with local waste
disposal authority, in accordance with national and regional regulations.

---

Section 14. Transportation information
Non-harzardous for air and ground transportation.

---

Section 15. Regulatory information
No chemicals in this material are subject to the reporting requirements of SARA Title III, Section
302, or have known CAS numbers that exceed the threshold reporting levels established by SARA
Title III, Section 313.

---

SECTION 16 - ADDITIONAL INFORMATION
N/A

反应信息

• 作为反应物：
  描述：

  7-溴-8-甲基喹啉 在 copper acetylacetonate 、 N1,N2-bis(4-hydroxy-2,6-dimethylphenyl)oxalamide 、 水 作用下， 以 水 、 二甲基亚砜 为溶剂， 反应 24.0h， 以95%的产率得到7-hydroxy-8-methylquinoline
  参考文献：
  名称：

  (杂)芳基卤化物在温和条件下的铜催化羟基化

  摘要：

  Cu(acac)2 和 N,N'-双(4-羟基-2,6-二甲基苯基)草酰胺 (BHMPO) 的组合为（杂）芳基卤化物的羟基化提供了强大的催化系统。各种带有给电子或吸电子基团的（杂）芳基氯化物在 130 °C 下均能很好地进行，以良好到极好的产率提供相应的酚类和羟基化杂芳烃。当使用反应性更强的（杂）芳基溴化物和碘化物时，羟基化反应在相对较低的温度（分别为 80 和 60 °C）下在低催化负载（0.5 mol% Cu）下完成。

  DOI：

  10.1021/jacs.6b08114
• 作为产物：
  描述：

  3-溴-2-甲基苯胺 生成 7-溴-8-甲基喹啉
  参考文献：
  名称：

  Ukai; Hashimoto; Higashi, Yakugaku Zasshi/Journal of the Pharmaceutical Society of Japan, 1928, vol. 48, p. 74

  摘要：

  DOI：

文献信息

• Ru(<scp>ii</scp>)-catalyzed amidation reactions of 8-methylquinolines with azides via C(sp³)–H activation
  作者：Bingxian Liu、Bin Li、Baiquan Wang

  DOI：10.1039/c5cc06230f

  日期：——

  The Ru(II)-catalyzed amidation reactions of 8-methylquinolines with azides have been developed. It is the first example of [(p-cymene)RuCl2]2-catalyzed C(sp3)-H bond intermolecular amidation reaction which give quinolin-8-ylmethanamines under mild reaction conditions...

  已经开发了Ru（II）催化的8-甲基喹啉与叠氮化物的酰胺化反应。这是[（对-异丙基）RuCl2] 2-催化的C（sp3）-H键分子间酰胺化反应的第一个例子，该反应在温和的反应条件下产生了喹啉-8-基甲胺。
• Deoxygenative Amination of Azine-<i>N</i>-oxides with Acyl Azides via [3 + 2] Cycloaddition
  作者：Dongeun Kim、Prithwish Ghosh、Na Yeon Kwon、Sang Hoon Han、Sangil Han、Neeraj Kumar Mishra、Saegun Kim、In Su Kim

  DOI：10.1021/acs.joc.9b03173

  日期：2020.2.21

  an isocyanate from the starting acyl azide via a Curtius rearrangement can trigger a [3 + 2] dipolar cycloaddition of polar N-oxide fragments to generate the aminated azine derivative. The applicability of this method is highlighted by the late-stage and sequential amination reactions of complex bioactive compounds, including quinidine and fasudil. Moreover, the direct transformation of aminated azines

  描述了一种无过渡金属的嗪-N-氧化物与酰基叠氮化物的脱氧CH胺化反应。通过库尔修斯重排从起始酰基叠氮化物初步形成异氰酸酯可以触发极性N-氧化物片段的[3 + 2]双极性环加成反应，从而生成胺化的嗪衍生物。复杂的生物活性化合物（包括奎尼丁和法舒地尔）的后期和顺序胺化反应突出了该方法的适用性。此外，将胺化嗪直接转化为各种生物活性的N-杂环说明了这种新开发的方案的重要性。
• Iodonium Ylides as Carbene Precursors in Rh(III)-Catalyzed C–H Activation
  作者：Yuqin Jiang、Pengfei Li、Jie Zhao、Bingxian Liu、Xingwei Li

  DOI：10.1021/acs.orglett.0c02618

  日期：2020.10.2

  The rhodium(III)-catalyzed coupling of C–H substrates with iodonium ylides has been realized for the efficient synthesis of diverse cyclic skeletons, where the iodonium ylides have been identified as efficient and outstanding carbene precursors. The reaction systems are applicable to both sp2 and sp3 C–H substrates under mild and redox-neutral conditions. The catalyst loading can be as low as 0.5 mol

  铑（III）催化的C–H底物与碘鎓碘化物的偶联已经实现了各种环状骨架的有效合成，其中碘鎓碘化物已被认为是有效且出色的卡宾前体。该反应系统适用于在轻度和氧化还原中性条件下的sp 2和sp 3 C–H底物。在克规模的反应中，催化剂的负载量可以低至0.5mol％。代表性产品在纳摩尔水平下对人癌细胞具有细胞毒性。
• Anthranil: An Aminating Reagent Leading to Bifunctionality for Both C(sp³)−H and C(sp²)−H under Rhodium(III) Catalysis
  作者：Songjie Yu、Guodong Tang、Yingzi Li、Xukai Zhou、Yu Lan、Xingwei Li

  DOI：10.1002/anie.201602224

  日期：2016.7.18

  nitrogenation suffered from simple amidation/amination with limited atom‐economy and is mostly limited to C(sp2)−H substrates. In this work, anthranil was designed as a novel bifunctional aminating reagent for both C(sp2)−H and C(sp3)−H bonds under rhodium(III) catalysis, thus affording a nucleophilic aniline tethered to an electrophilic carbonyl. A tridendate rhodium(III) complex has been isolated as the

  以前的直接CH H氮化反应受简单的酰胺化/胺化作用和原子经济的限制，并且大多限于C（sp 2）-H底物。在这项工作中，将蒽醌设计为在铑（III）催化下同时用于C（sp 2）-H和C（sp 3）-H键的新型双功能胺化试剂，从而提供了拴接到亲电羰基的亲核苯胺。已经分离出三登酸盐铑（III）配合物作为催化剂的静止状态，DFT研究确定了亚硝基物质的中间体。
• Rh-Catalyzed Direct Amination of Unactivated C(sp³ )−H bond with Anthranils Under Mild Conditions
  作者：Conghui Tang、Miancheng Zou、Jianzhong Liu、Xiaojin Wen、Xiang Sun、Yiqun Zhang、Ning Jiao

  DOI：10.1002/chem.201602556

  日期：2016.8.1

  C−N Bond formation is of great significance due to the ubiquity of nitrogen‐containing compounds. Here, a mild and efficient RhIII‐catalyzed C(sp3)−H aryl amination reaction is reported. Anthranil is employed as the nitrogen source with 100 % atom efficiency. This C−H amination reaction exhibits broad substrate scope without using any external oxidants. Mechanistic studies including rhodacycle intermediates

  由于含氮化合物的普遍存在，C N键的形成具有重要意义。在这里，报告了温和有效的Rh III催化的C（sp 3）-H芳基胺化反应。蒽被用作氮源，原子效率为100％。这种CH氨基化反应在不使用任何外部氧化剂的情况下具有广泛的底物范围。介绍了机理研究，包括Rhodacycle中间体，H-D交换，动力学同位素效应（KIE）实验和原位IR。