3-(癸基二甲基硅烷基)-N-(2-(4-甲基苯基)-1-苯基乙基)丙酰胺 | 78934-83-5

• 物质功能分类: 有机原料 - 杂环化合物
• 分子结构分类: 有机化合物 - 苯丙烷和聚酮 - 二苯乙烯类
• 中文名称: 3-(癸基二甲基硅烷基)-N-(2-(4-甲基苯基)-1-苯基乙基)丙酰胺
• 英文名称: Sah 58-035
• 英文别名: SANDOS 58-035；Sandoz 58-035；(+/-)-4,4-dimethyl-4-sila-tetradecanoyl-1'-phenyl-2'-p-tolyl-ethylamide；3-[decyldimethylsilyl]-N-[2-(4-methylphenyl)-1-phenethyl]propanamide；3-[decyl(dimethyl)silyl]-N-[2-(4-methylphenyl)-1-phenylethyl]propanamide
• CAS: 78934-83-5
• 化学式: C₃₀H₄₇NOSi
• 分子量: 465.795
• InChiKey: NBYATBIMYLFITE-UHFFFAOYSA-N

物化性质

• 溶解度：
  二甲基亚砜：16 毫克/毫升

计算性质

• 辛醇/水分配系数(LogP)：
  8.63
• 重原子数：
  33
• 可旋转键数：
  16
• 环数：
  2.0
• sp3杂化的碳原子比例：
  0.57
• 拓扑面积：
  29.1
• 氢给体数：
  1
• 氢受体数：
  1

安全信息

• WGK Germany：
  3
• 储存条件：
  2-8°C

SDS

---

Section 1. IDENTIFICATION OF THE SUBSTANCE/MIXTURE
Product identifiers
Product name : Sandoz 58-035
CAS-No. : 78934-83-5
Relevant identified uses of the substance or mixture and uses advised against
Identified uses : Laboratory chemicals, Manufacture of substances

---

Section 2. HAZARDS IDENTIFICATION
Classification of the substance or mixture
Not a hazardous substance or mixture according to Regulation (EC) No 1272/2008
This substance is not classified as dangerous according to Directive 67/548/EEC.
Label elements
Caution - substance not yet tested completely.
Other hazards - none

---

Section 3. COMPOSITION/INFORMATION ON INGREDIENTS
Substances
Synonyms : 3-[Decyldimethylsilyl]-N-[2-(4-methylphenyl)-1-phenethyl]propanamide
SA 58-035
Formula : C30H47NOSi
Molecular Weight : 465,79 g/mol

---

Section 4. FIRST AID MEASURES
Description of first aid measures
If inhaled
If breathed in, move person into fresh air. If not breathing, give artificial respiration.
In case of skin contact
Wash off with soap and plenty of water.
In case of eye contact
Flush eyes with water as a precaution.
If swallowed
Never give anything by mouth to an unconscious person. Rinse mouth with water.
Most important symptoms and effects, both acute and delayed
Indication of any immediate medical attention and special treatment needed
no data available

---

Section 5. FIREFIGHTING MEASURES
Extinguishing media
Suitable extinguishing media
Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
Special hazards arising from the substance or mixture
Carbon oxides, nitrogen oxides (NOx), silicon oxides
Advice for firefighters
Wear self contained breathing apparatus for fire fighting if necessary.
Further information
no data available

---

Section 6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
Avoid dust formation. Avoid breathing vapors, mist or gas.
Environmental precautions
Do not let product enter drains.
Methods and materials for containment and cleaning up
Sweep up and shovel. Keep in suitable, closed containers for disposal.
Reference to other sections
For disposal see section 13.

---

Section 7. HANDLING AND STORAGE
Precautions for safe handling
Provide appropriate exhaust ventilation at places where dust is formed.Normal measures for preventive fire
protection.
Conditions for safe storage, including any incompatibilities
Store in cool place. Keep container tightly closed in a dry and well-ventilated place.
Recommended storage temperature: 2 - 8 °C
Specific end uses
no data available

---

Section 8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Control parameters
Components with workplace control parameters
Exposure controls
Appropriate engineering controls
General industrial hygiene practice.
Personal protective equipment
Eye/face protection
Use equipment for eye protection tested and approved under appropriate government standards
such as NIOSH (US) or EN 166(EU).
Skin protection
Handle with gloves. Gloves must be inspected prior to use. Use proper glove removal technique
(without touching glove's outer surface) to avoid skin contact with this product. Dispose of
contaminated gloves after use in accordance with applicable laws and good laboratory practices.
Wash and dry hands.
The selected protective gloves have to satisfy the specifications of EU Directive 89/686/EEC and
the standard EN 374 derived from it.
Body Protection
Choose body protection in relation to its type, to the concentration and amount of dangerous
substances, and to the specific work-place., The type of protective equipment must be selected
according to the concentration and amount of the dangerous substance at the specific workplace.
Respiratory protection
Respiratory protection is not required. Where protection from nuisance levels of dusts are desired,
use type N95 (US) or type P1 (EN 143) dust masks. Use respirators and components tested and
approved under appropriate government standards such as NIOSH (US) or CEN (EU).

---

Section 9. PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
a) Appearance Form: solid
b) Odour no data available
c) Odour Threshold no data available
d) pH no data available
e) Melting point/freezing no data available
point
f) Initial boiling point and no data available
boiling range
g) Flash point no data available
h) Evaporation rate no data available
i) Flammability (solid, gas) no data available
j) Upper/lower no data available
flammability or
explosive limits
k) Vapour pressure no data available
l) Vapour density no data available
m) Relative density no data available
n) Water solubility no data available
o) Partition coefficient: n- no data available
octanol/water
p) Autoignition no data available
temperature
q) Decomposition no data available
temperature
r) Viscosity no data available
s) Explosive properties no data available
t) Oxidizing properties no data available
Other safety information
no data available

---

Section 10. STABILITY AND REACTIVITY
Reactivity
no data available
Chemical stability
no data available
Possibility of hazardous reactions
no data available
Conditions to avoid
no data available
Incompatible materials
Strong oxidizing agents
Hazardous decomposition products
Other decomposition products - no data available

---

Section 11. TOXICOLOGICAL INFORMATION
Information on toxicological effects
Acute toxicity
no data available
Skin corrosion/irritation
no data available
Serious eye damage/eye irritation
no data available
Respiratory or skin sensitization
no data available
Germ cell mutagenicity
no data available
Carcinogenicity
IARC: No component of this product present at levels greater than or equal to 0.1% is identified as
probable, possible or confirmed human carcinogen by IARC.
Reproductive toxicity
no data available
Specific target organ toxicity - single exposure
no data available
Specific target organ toxicity - repeated exposure
no data available
Aspiration hazard
no data available
Potential health effects
Inhalation
May be harmful if inhaled. May cause respiratory tract irritation.
Ingestion May be harmful if swallowed.
Skin May be harmful if absorbed through skin. May cause skin irritation.
Eyes May cause eye irritation.
Additional Information
RTECS: Not available

---

Section 12. ECOLOGICAL INFORMATION
Toxicity
no data available
Persistence and degradability
no data available
Bioaccumulative potential
no data available
Mobility in soil
no data available
Results of PBT and vPvB assessment
no data available
Other adverse effects
no data available

---

Section 13. DISPOSAL CONSIDERATIONS
Waste treatment methods
Product
Offer surplus and non-recyclable solutions to a licensed disposal company.
Contaminated packaging
Dispose of as unused product.

---

Section 14. TRANSPORT INFORMATION
UN number
ADR/RID: - IMDG: - IATA: -
UN proper shipping name
ADR/RID: Not dangerous goods
IMDG: Not dangerous goods
IATA: Not dangerous goods
Transport hazard class(es)
ADR/RID: - IMDG: - IATA: -
Packaging group
ADR/RID: - IMDG: - IATA: -
Environmental hazards
ADR/RID: no IMDG Marine pollutant: no IATA: no
Special precautions for user
no data available

---

---

SECTION 15 - REGULATORY INFORMATION
N/A

---

SECTION 16 - ADDITIONAL INFORMATION
N/A

制备方法与用途

Sandoz 58-035 可以同时诱导小鼠腹腔巨噬细胞中的未折叠蛋白反应（UPR）和模式识别受体（PRR）。

反应信息

• 作为产物：
  描述：

  4,4-Dimethyl-4-sila-pentanoyl-(1'-phenyl-2'-p-tolyl)-ethylamide 在 iron(III) chloride 、 二苯基亚砜 、 四乙基氯化铵 、 caesium carbonate 作用下， 以 氯苯 、 丙酮 、 乙腈 为溶剂， 反应 12.0h， 生成 3-(癸基二甲基硅烷基)-N-(2-(4-甲基苯基)-1-苯基乙基)丙酰胺
  参考文献：
  名称：

  通过分子间自由基取样进行末端 C(sp 3 )–H 硼化

  摘要：

  氢原子转移 (HAT) 过程可以克服惰性 C(sp) 的强键解离能 (BDE) 3 )–H键，从而将原料烷烃转化为高附加值的精细化学品。尽管如此，HAT 试剂的高反应活性，加上各种 C(sp 3 )–H键强度，使得直链烷烃的位点选择性转化成为一个巨大的挑战。在这里，我们提出了一种光催化分子间自由基采样过程，用于铁催化末端 C(sp 3 )–H 键存在于具有小空间位阻的底物中，包括无支链烷烃。机理研究表明，该反应通过可逆的 HAT 过程进行，然后进行碳自由基的选择性硼化。硼-亚砜络合物可能有助于观察到高末端区域选择性。

  DOI：

  10.1126/science.adj9258