Material Safety Data Sheet Section 1. Identification of the substance 4-Benzyloxy-2-methylphenylboronic acid Product Name: Synonyms: 5-Benzyloxytoluene-2-boronic acid Section 2. Hazards identification Harmful by inhalation, in contact with skin, and if swallowed. H315: Causes skin irritation H319: Causes serious eye irritation H335: May cause respiratory irritation P261: Avoid breathing dust/fume/gas/mist/vapours/spray Wear protective gloves/protective clothing/eye protection/face protection P280: P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do – continue rinsing P304+P340: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing P405: Store locked up Section 3. Composition/information on ingredients. 4-Benzyloxy-2-methylphenylboronic acid Ingredient name: CAS number: 847560-49-0 Section 4. First aid measures Immediately wash skin with copious amounts of water for at least 15 minutes while removing Skin contact: contaminated clothing and shoes. If irritation persists, seek medical attention. Eye contact: Immediately wash skin with copious amounts of water for at least 15 minutes. Assure adequate flushing of the eyes by separating the eyelids with fingers. If irritation persists, seek medical attention. Inhalation: Remove to fresh air. In severe cases or if symptoms persist, seek medical attention. Wash out mouth with copious amounts of water for at least 15 minutes. Seek medical attention. Ingestion: Section 5. Fire fighting measures In the event of a fire involving this material, alone or in combination with other materials, use dry powder or carbon dioxide extinguishers. Protective clothing and self-contained breathing apparatus should be worn. Section 6. Accidental release measures Personal precautions: Wear suitable personal protective equipment which performs satisfactorily and meets local/state/national standards. Respiratory precaution: Wear approved mask/respirator Hand precaution: Wear suitable gloves/gauntlets Skin protection: Wear suitable protective clothing Eye protection: Wear suitable eye protection Methods for cleaning up: Mix with sand or similar inert absorbent material, sweep up and keep in a tightly closed container for disposal. See section 12. Environmental precautions: Do not allow material to enter drains or water courses. Section 7. Handling and storage Handling: This product should be handled only by, or under the close supervision of, those properly qualified in the handling and use of potentially hazardous chemicals, who should take into account the fire, health and chemical hazard data given on this sheet. Storage: Store in closed vessels. Section 8. Exposure Controls / Personal protection Engineering Controls: Use only in a chemical fume hood. Personal protective equipment: Wear laboratory clothing, chemical-resistant gloves and safety goggles. General hydiene measures: Wash thoroughly after handling. Wash contaminated clothing before reuse. Section 9. Physical and chemical properties Not specified Appearance: Boiling point: No data Melting point: No data Flash point: No data Density: No data Molecular formula: C14H15BO3 Molecular weight: 242.1 Section 10. Stability and reactivity Conditions to avoid: Heat, flames and sparks. Materials to avoid: Oxidizing agents. Possible hazardous combustion products: Carbon monoxide. Section 11. Toxicological information No data. Section 12. Ecological information No data. Section 13. Disposal consideration Arrange disposal as special waste, by licensed disposal company, in consultation with local waste disposal authority, in accordance with national and regional regulations. Section 14. Transportation information Non-harzardous for air and ground transportation. Section 15. Regulatory information No chemicals in this material are subject to the reporting requirements of SARA Title III, Section 302, or have known CAS numbers that exceed the threshold reporting levels established by SARA Title III, Section 313.
Thermotropic and Lyotropic Liquid Crystalline Phases of Rigid Aromatic Amphiphiles
摘要:
Rodlike amphiphilic molecules that contain exclusively aromatic building-blocks and no flexible alkyl chains have been synthesized and their mesomorphic properties investigated. These novel compounds bear diol head groups of different size (2,3-dihydroxypropyloxy or 5,6-dihydroxy-3-oxahexyloxy groups) at one end of a biphenyl unit, various aromatic segments (banzyloxy, 4-, 3-, or 2-methylbenzyloxy, phenoxy groups) at the other, and additional methyl substituents in different positions. They were synthesized by using Suzuki cross-coupling reactions as the key steps. Their thermotropic mesomorphism was investigated by means of polarized light optical microscopy, differential scanning calorimetry, and, for enantiotropic phases, by X-ray scattering. The liquid crystallinity of this class of compounds is influenced by protic solvents, such as water and glycerol. Dependent on the temperature and the solvent content, different S-A phases were found. Several mesophases resulting from the frustration of these layer structures (e.g., different columnar phases, optical isotropic mesophases, and nematic phases) were also present. The smectic phases have different degrees of intercalation (S-Ad, S-A2) The columnar phases are supposed to be ribbon structures that result from the collapse of the smectic layers. They occur in some pure compounds or they are induced upon the addition of protic solvents. The particular phase sequences of the different compounds depend mainly on the position of the methyl substituents at the biphenyl cores and are largely determined by the degree of intercalation of the aromatic cores.
Thermotropic and Lyotropic Liquid Crystalline Phases of Rigid Aromatic Amphiphiles
摘要:
Rodlike amphiphilic molecules that contain exclusively aromatic building-blocks and no flexible alkyl chains have been synthesized and their mesomorphic properties investigated. These novel compounds bear diol head groups of different size (2,3-dihydroxypropyloxy or 5,6-dihydroxy-3-oxahexyloxy groups) at one end of a biphenyl unit, various aromatic segments (banzyloxy, 4-, 3-, or 2-methylbenzyloxy, phenoxy groups) at the other, and additional methyl substituents in different positions. They were synthesized by using Suzuki cross-coupling reactions as the key steps. Their thermotropic mesomorphism was investigated by means of polarized light optical microscopy, differential scanning calorimetry, and, for enantiotropic phases, by X-ray scattering. The liquid crystallinity of this class of compounds is influenced by protic solvents, such as water and glycerol. Dependent on the temperature and the solvent content, different S-A phases were found. Several mesophases resulting from the frustration of these layer structures (e.g., different columnar phases, optical isotropic mesophases, and nematic phases) were also present. The smectic phases have different degrees of intercalation (S-Ad, S-A2) The columnar phases are supposed to be ribbon structures that result from the collapse of the smectic layers. They occur in some pure compounds or they are induced upon the addition of protic solvents. The particular phase sequences of the different compounds depend mainly on the position of the methyl substituents at the biphenyl cores and are largely determined by the degree of intercalation of the aromatic cores.
The present invention provides compounds of Formula (I):
or a stereoisomer, or a pharmaceutically acceptable salt thereof, wherein all of the variables are as defined herein. These compounds are GPR40 G protein-coupled receptor modulators which may be used as medicaments.
[EN] HETEROAROMATIC COMPOUNDS AND THEIR USE AS DOPAMINE D1 LIGANDS<br/>[FR] COMPOSÉS HÉTÉRO-AROMATIQUES ET LEUR UTILISATION EN TANT QUE LIGANDS D1 DE LA DOPAMINE
申请人:PFIZER
公开号:WO2014207601A1
公开(公告)日:2014-12-31
The present invention provides, in part, compounds of Formula (I) and pharmaceutically acceptable salts thereof; processes for the preparation of; intermediates used in the preparation of; and compositions containing such compounds or salts, and their uses for treating D1 -mediated (or D1 -associated) disorders including, e.g., schizophrenia (e.g., its cognitive and negative symptoms), cognitive impairment (e.g., cognitive impairment associated with schizophrenia, AD, PD, or pharmacotherapy therapy), age-related cognitive decline, dementia, and Parkinson's disease.
first time with arylboronicacids as nucleophiles. This transition‐metal‐free coupling between chiral α‐aryl‐α‐mesylated acetamides and arylboronicacids provided access to a series of chiral α,α‐diaryl acetamides with excellent enantioselectivity and moderate to good yields. The CONH functionality proved to be crucial for bridging the reactants and promoting the reaction. Efficient syntheses of a cannabinoid
Polysubstituted Pyrimidines as mPGES‐1 Inhibitors: Discovery of Potent Inhibitors of PGE
<sub>2</sub>
Production with Strong Anti‐inflammatory Effects in Carrageenan‐Induced Rat Paw Edema
These compounds are sub‐micromolar inhibitors of PGE2 production (IC50 as low as 12 nM). In order to identify the molecular target of anti‐inflammatory pyrimidines, we performed extensive studies including enzymatic assays, homology modeling and docking. The difluorinated analogue simultaneously inhibits two key enzymes of the arachidonicacidcascade, namely mPGES‐1 and COX‐2, with mPGES‐1 inhibition
Compounds of formula (1) are inhibitors of HSP90 activity in vitro or in vivo, and of use in the treatment of inter alia, cancer: wherein R2 is a group of formula -(Ar1)m-(Alk1)P-(Z)r-(Alk2)S-Q wherein Ar1 is an optionally substituted aryl or heteroaryl radical, Alk' and Alk 2 are optionally substituted divalent C1-C3 alkylene or C2-C3 alkenylene radicals, m, p, r and s are independently 0 or 1, Z is -0-, -S-, -(C=O)-, -(C=S)-, -S02-, -C(=O)O-, -C(=O) NR A- , -C(=S)NR A-, -S02NR A-, -NR AC(=O)_, -NR AS02- or-NR A-wherein R A is hydrogen or C1-C6 alkyl, and Q is hydrogen or an optionally substituted carbocyclic or heterocyclic radical; R3 is hydrogen, an optional substituent, or an optionally substituted (C1-C6)alkyl, aryl or heteroaryl radical; and R4 is a carboxylic ester, carboxamide or sulfonamide group.