3-异丁酰胺基苯基硼酸 | 874459-76-4

• 分子结构分类: 有机化合物 - 苯类化合物 - 苯和取代衍生物
• 中文名称: 3-异丁酰胺基苯基硼酸
• 中文别名: 3-异丁酰氨基苯硼酸
• 英文名称: 3-isobutyramidophenylboronic acid
• 英文别名: (3-(isobutyramido)phenyl)boronic acid；3-(Isobutyramido)benzeneboronic acid；[3-(2-methylpropanoylamino)phenyl]boronic acid
• CAS: 874459-76-4
• 化学式: C₁₀H₁₄BNO₃
• mdl: MFCD08235080
• 分子量: 207.037
• InChiKey: HXBVOKMSEWLCKA-UHFFFAOYSA-N

物化性质

• 熔点：
  275-277
• 密度：
  1.16

计算性质

• 辛醇/水分配系数(LogP)：
  2.16
• 重原子数：
  15
• 可旋转键数：
  3
• 环数：
  1.0
• sp3杂化的碳原子比例：
  0.3
• 拓扑面积：
  69.6
• 氢给体数：
  3
• 氢受体数：
  3

安全信息

• 危险品标志：
  Xi
• 海关编码：
  2931900090

SDS

Material Safety Data Sheet

---

Section 1. Identification of the substance
3-Isobutyramidophenylboronic acid
Product Name:
Synonyms:

---

Section 2. Hazards identification
Harmful by inhalation, in contact with skin, and if swallowed.
H315: Causes skin irritation
H319: Causes serious eye irritation
H335: May cause respiratory irritation
P261: Avoid breathing dust/fume/gas/mist/vapours/spray
Wear protective gloves/protective clothing/eye protection/face protection
P280:
P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present
and easy to do – continue rinsing
P304+P340: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing
P405: Store locked up

---

Section 3. Composition/information on ingredients.
3-Isobutyramidophenylboronic acid
Ingredient name:
CAS number: 874459-76-4

---

Section 4. First aid measures
Immediately wash skin with copious amounts of water for at least 15 minutes while removing
Skin contact:
contaminated clothing and shoes. If irritation persists, seek medical attention.
Eye contact: Immediately wash skin with copious amounts of water for at least 15 minutes. Assure adequate
flushing of the eyes by separating the eyelids with fingers. If irritation persists, seek medical
attention.
Inhalation: Remove to fresh air. In severe cases or if symptoms persist, seek medical attention.
Wash out mouth with copious amounts of water for at least 15 minutes. Seek medical attention.
Ingestion:

---

Section 5. Fire fighting measures
In the event of a fire involving this material, alone or in combination with other materials, use dry
powder or carbon dioxide extinguishers. Protective clothing and self-contained breathing apparatus
should be worn.

---

Section 6. Accidental release measures
Personal precautions: Wear suitable personal protective equipment which performs satisfactorily and meets local/state/national
standards.
Respiratory precaution: Wear approved mask/respirator
Hand precaution: Wear suitable gloves/gauntlets
Skin protection: Wear suitable protective clothing
Eye protection: Wear suitable eye protection
Methods for cleaning up: Mix with sand or similar inert absorbent material, sweep up and keep in a tightly closed container
for disposal. See section 12.
Environmental precautions: Do not allow material to enter drains or water courses.

---

Section 7. Handling and storage
Handling: This product should be handled only by, or under the close supervision of, those properly qualified
in the handling and use of potentially hazardous chemicals, who should take into account the fire,
health and chemical hazard data given on this sheet.
Storage: Store in closed vessels.

---

Section 8. Exposure Controls / Personal protection
Engineering Controls: Use only in a chemical fume hood.
Personal protective equipment: Wear laboratory clothing, chemical-resistant gloves and safety goggles.
General hydiene measures: Wash thoroughly after handling. Wash contaminated clothing before reuse.

---

Section 9. Physical and chemical properties
Not specified
Appearance:
Boiling point: No data
Melting point: No data
Flash point: No data
Density: No data
Molecular formula: C10H14BNO3
Molecular weight: 207.0

---

Section 10. Stability and reactivity
Conditions to avoid: Heat, flames and sparks.
Materials to avoid: Oxidizing agents.
Possible hazardous combustion products: Carbon monoxide, nitrogen oxides.

---

Section 11. Toxicological information
No data.

---

Section 12. Ecological information
No data.

---

Section 13. Disposal consideration
Arrange disposal as special waste, by licensed disposal company, in consultation with local waste
disposal authority, in accordance with national and regional regulations.

---

Section 14. Transportation information
Non-harzardous for air and ground transportation.

---

Section 15. Regulatory information
No chemicals in this material are subject to the reporting requirements of SARA Title III, Section
302, or have known CAS numbers that exceed the threshold reporting levels established by SARA
Title III, Section 313.

---

SECTION 16 - ADDITIONAL INFORMATION
N/A

反应信息

• 作为反应物：
  描述：

  3-异丁酰胺基苯基硼酸 在 copper(ll) sulfate pentahydrate 、 鞣花酸 作用下， 以 甲醇 为溶剂， 60.0 ℃ 、101.33 kPa 条件下， 反应 8.0h， 以72%的产率得到N-(3-羟基苯基)-2-甲基丙酰胺
  参考文献：
  名称：

  Oxidative hydroxylation of arylboronic acids to phenols catalyzed by copper nanoparticles ellagic acid composite

  摘要：

  Copper nanoparticles (Cu NPs) were prepared by in situ reduction of CuSO4 center dot 5H(2)O using ellagic acid (EA) as the reducing agent as well as stabilizer and its catalytic activity is tested in the oxidative hydroxylation of phenylboronic acids to phenol without any added base or ligand. The synthesized Cu NPs-EA composite was characterized by UV-Vis., FT-IR, powder XRD and HRTEM analyses. The average particle size of Cu NPs is found to be in the range of 20-25 nm as evident from HRTEM and copper content is estimated to be 3.18 wt%. EA acts both as a reducing agent as well as a stabilizer for the in situ formation of Cu NPs. A small portion of Cu NPs is also found to undergo aerobic oxidation to give Cu2O NPs which does not take part in the reactions. A series of arylboronic acids are converted to the corresponding phenols in high yields at short reaction time under milder reaction conditions. It is also observed that Cu NPs-EA composite can be reused at least four times with a significant decrease in the yield. (C) 2014 Elsevier B.V. All rights reserved.

  DOI：

  10.1016/j.molcata.2014.09.016

文献信息

• [EN] ANTIVIRAL COMPOUNDS<br/>[FR] COMPOSÉS ANTIVIRAUX
  申请人：HOFFMANN LA ROCHE

  公开号：WO2014135495A1

  公开（公告）日：2014-09-12

  The present invention discloses compounds of Formula I: wherein the variables in Formula I are defined as described herein. Also disclosed are pharmaceutical compositions containing such compounds and methods for using the compounds of Formula I in the prevention or treatment of HCV infection.

  本发明公开了化合物的结构式I：其中结构式I中的变量如本文所述。还公开了含有这些化合物的药物组合物，以及使用结构式I中的化合物预防或治疗HCV感染的方法。
• [EN] COMPOUNDS FOR TREATMENT OF DUCHENNE MUSCULAR DYSTROPHY<br/>[FR] COMPOSÉS DESTINÉS AU TRAITEMENT DE LA DYSTROPHIE MUSCULAIRE DE DUCHENNE
  申请人：BIOMARIN IGA LTD

  公开号：WO2010069684A1

  公开（公告）日：2010-06-24

  Compounds of formula (I): wherein R1, R2, X1, and X2 are as defined herein, are useful for the treatment or prophylaxis of conditions such as Duchenne muscular dystrophy, Becker muscular dystrophy, and cachexia.

  式(I)的化合物：其中R1、R2、X1和X2如本文所定义，可用于治疗或预防杜兴氏肌肉萎缩症、贝克氏肌肉萎缩症和消瘦症等疾病。
• ANTIVIRAL COMPOUNDS
  申请人：HOFFMANN-LA ROCHE INC.

  公开号：US20160000760A1

  公开（公告）日：2016-01-07

  The present invention discloses compounds of Formula I: wherein the variables in Formula I are defined as described herein. Also disclosed are pharmaceutical compositions containing such compounds and methods for using the compounds of Formula I in the prevention or treatment of HCV infection.

  本发明公开了I式化合物：其中I式中的变量如本文所述。还公开了包含这种化合物的药物组合物，以及使用I式化合物在预防或治疗HCV感染方面的方法。
• Oxidative hydroxylation of arylboronic acids to phenols catalyzed by copper nanoparticles ellagic acid composite
  作者：Abdullah Affrose、Ismail Abulkalam Azath、Amarajothi Dhakshinamoorthy、Kasi Pitchumani

  DOI：10.1016/j.molcata.2014.09.016

  日期：2014.12

  Copper nanoparticles (Cu NPs) were prepared by in situ reduction of CuSO4 center dot 5H(2)O using ellagic acid (EA) as the reducing agent as well as stabilizer and its catalytic activity is tested in the oxidative hydroxylation of phenylboronic acids to phenol without any added base or ligand. The synthesized Cu NPs-EA composite was characterized by UV-Vis., FT-IR, powder XRD and HRTEM analyses. The average particle size of Cu NPs is found to be in the range of 20-25 nm as evident from HRTEM and copper content is estimated to be 3.18 wt%. EA acts both as a reducing agent as well as a stabilizer for the in situ formation of Cu NPs. A small portion of Cu NPs is also found to undergo aerobic oxidation to give Cu2O NPs which does not take part in the reactions. A series of arylboronic acids are converted to the corresponding phenols in high yields at short reaction time under milder reaction conditions. It is also observed that Cu NPs-EA composite can be reused at least four times with a significant decrease in the yield. (C) 2014 Elsevier B.V. All rights reserved.