Material Safety Data Sheet Section 1. Identification of the substance N-Cyclohexyl 4-chlorobenzamide Product Name: Synonyms: 4-Chloro-N-cyclohexylbenzamide Section 2. Hazards identification Harmful by inhalation, in contact with skin, and if swallowed. H315: Causes skin irritation H319: Causes serious eye irritation H335: May cause respiratory irritation P261: Avoid breathing dust/fume/gas/mist/vapours/spray P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do – continue rinsing P302+P352: IF ON SKIN: Wash with soap and water P321: Specific treatment (see on this label) P405: Store locked up Section 3. Composition/information on ingredients. N-Cyclohexyl 4-chlorobenzamide Ingredient name: CAS number: 57707-20-7 Section 4. First aid measures Immediately wash skin with copious amounts of water for at least 15 minutes while removing Skin contact: contaminated clothing and shoes. If irritation persists, seek medical attention. Eye contact: Immediately wash skin with copious amounts of water for at least 15 minutes. Assure adequate flushing of the eyes by separating the eyelids with fingers. If irritation persists, seek medical attention. Inhalation: Remove to fresh air. In severe cases or if symptoms persist, seek medical attention. Wash out mouth with copious amounts of water for at least 15 minutes. Seek medical attention. Ingestion: Section 5. Fire fighting measures In the event of a fire involving this material, alone or in combination with other materials, use dry powder or carbon dioxide extinguishers. Protective clothing and self-contained breathing apparatus should be worn. Section 6. Accidental release measures Personal precautions: Wear suitable personal protective equipment which performs satisfactorily and meets local/state/national standards. Respiratory precaution: Wear approved mask/respirator Hand precaution: Wear suitable gloves/gauntlets Skin protection: Wear suitable protective clothing Eye protection: Wear suitable eye protection Methods for cleaning up: Mix with sand or similar inert absorbent material, sweep up and keep in a tightly closed container for disposal. See section 12. Environmental precautions: Do not allow material to enter drains or water courses. Section 7. Handling and storage Handling: This product should be handled only by, or under the close supervision of, those properly qualified in the handling and use of potentially hazardous chemicals, who should take into account the fire, health and chemical hazard data given on this sheet. Storage: Store in closed vessels. Section 8. Exposure Controls / Personal protection Engineering Controls: Use only in a chemical fume hood. Personal protective equipment: Wear laboratory clothing, chemical-resistant gloves and safety goggles. General hydiene measures: Wash thoroughly after handling. Wash contaminated clothing before reuse. Section 9. Physical and chemical properties Not specified Appearance: Boiling point: No data Melting point: No data Flash point: No data Density: No data Molecular formula: C13H16ClNO Molecular weight: 237.7 Section 10. Stability and reactivity Conditions to avoid: Heat, flames and sparks. Materials to avoid: Oxidizing agents. Possible hazardous combustion products: Carbon monoxide, nitrogen oxides, hydrogen chloride. Section 11. Toxicological information No data. Section 12. Ecological information No data. Section 13. Disposal consideration Arrange disposal as special waste, by licensed disposal company, in consultation with local waste disposal authority, in accordance with national and regional regulations. Section 14. Transportation information Non-harzardous for air and ground transportation. Section 15. Regulatory information No chemicals in this material are subject to the reporting requirements of SARA Title III, Section 302, or have known CAS numbers that exceed the threshold reporting levels established by SARA Title III, Section 313.
SECTION 16 - ADDITIONAL INFORMATION N/A
反应信息
作为反应物:
描述:
4-氯-N-环己基苯甲酰胺 在
氯化亚砜 作用下,
以7.4 g (54%)的产率得到N-cyclohexyl 4-chlorobenzimidoyl chloride
mechanochemical synthesis of amides from carboxylic acids has been developed through an in situ acid activation with 2,4,6-trichloro-1,3,5-triazine and a catalytic amount of PPh3. Under room temperature solvent-drop grinding of the reactants in the presence of an inorganic base, a variety of carboxylic acids including aromatic acids, aliphatic acids, and N-protected α-amino acids undergo amidation to afford
The catalytic role of PPh3 and its polymer bound analog was investigated in the 2,4,6-trichloro-1,3,5-triazine (TCT) mediated amidation of carboxylicacids. In the presence of inorganic bases which were inert toward TCT, carboxylicacids rapidly reacted with amines to afford amides in good to excellent yields. The described method also enabled the synthesis of optically active protected dipeptides
在2,4,6-三氯-1,3,5-三嗪(TCT)介导的羧酸酰胺化反应中,研究了PPh 3及其与聚合物结合的类似物的催化作用。在对TCT呈惰性的无机碱的存在下,羧酸与胺迅速反应,以良好或优异的收率得到酰胺。所描述的方法还能够在没有外消旋的情况下合成旋光保护的二肽。根据31 P NMR研究证实,在PPh 3催化的酸活化过程中形成了三嗪基氯化chloride 。
Amidines. VII. Hydrolysis and alcoholysis of carboxamides under mild conditions.
Hydrolysis and alcoholysis of carboxamides derived from primary aliphatic amines were achieved under mild conditions. Amide exchange reaction between carboxamides and N1-acyl-N1, N2-di (p-nitrophenyl) formamidines (1) gave N1-acyl-N1-alkyl-N2-(p-nitrophenyl)formamidines (2) which were readily hydrolyzed or alcoholyzed to give N1-alkyl-N2-(p-nitrophenyl)formamidines (4) and carboxylic acid or its ester. Compounds 4 were hydrolyzed to give aliphatic amine and N-formyl-p-nitroaniline in the presence of acetic acid or hydrochloric acid at room temperature. For the alcoholysis of N-acyl derivatives of amino alcohols, protection of the hydroxyl substituent by an acyl group was essential because the reaction of 1 and N-acyl derivatives of amino alcohols was quite complex. Alcoholysis of N-ethyl-N, N'-ethylenebis (p-chlorobenzamide) (8a) by this method gave N-(2-aminoethyl)-N-ethyl-p-chlorobenzamide (8b). Thus, the selective alcoholysis of diacyl derivative of diamines, which contain primary and secondary amino groups, was achieved.
Copper(II)-Photocatalyzed N–H Alkylation with Alkanes
作者:Yi-Wen Zheng、Rok Narobe、Karsten Donabauer、Shahboz Yakubov、Burkhard König
DOI:10.1021/acscatal.0c01924
日期:2020.8.7
of N–H bonds with alkanes using a photoinduced copper(II) peroxide catalytic system. Upon light irradiation, the peroxide serves as a hydrogen atom transfer reagent to activate stable C(sp3)–H bonds for the reaction with a broad range of nitrogen nucleophiles. The method enables the chemoselective alkylation of amides and is utilized for the late-stage functionalization of N–H bond containing pharmaceuticals