Material Safety Data Sheet Section 1. Identification of the substance Product Name: 2-Cycloheptyl-ethylamine Synonyms: Section 2. Hazards identification Harmful by inhalation, in contact with skin, and if swallowed. Section 3. Composition/information on ingredients. Ingredient name: 2-Cycloheptyl-ethylamine CAS number: 4448-84-4 Section 4. First aid measures Skin contact: Immediately wash skin with copious amounts of water for at least 15 minutes while removing contaminated clothing and shoes. If irritation persists, seek medical attention. Eye contact: Immediately wash skin with copious amounts of water for at least 15 minutes. Assure adequate flushing of the eyes by separating the eyelids with fingers. If irritation persists, seek medical attention. Inhalation: Remove to fresh air. In severe cases or if symptoms persist, seek medical attention. Ingestion: Wash out mouth with copious amounts of water for at least 15 minutes. Seek medical attention. Section 5. Fire fighting measures In the event of a fire involving this material, alone or in combination with other materials, use dry powder or carbon dioxide extinguishers. Protective clothing and self-contained breathing apparatus should be worn. Section 6. Accidental release measures Personal precautions: Wear suitable personal protective equipment which performs satisfactorily and meets local/state/national standards. Respiratory precaution: Wear approved mask/respirator Hand precaution: Wear suitable gloves/gauntlets Skin protection: Wear suitable protective clothing Eye protection: Wear suitable eye protection Methods for cleaning up: Mix with sand or similar inert absorbent material, sweep up and keep in a tightly closed container for disposal. See section 12. Environmental precautions: Do not allow material to enter drains or water courses. Section 7. Handling and storage Handling: This product should be handled only by, or under the close supervision of, those properly qualified in the handling and use of potentially hazardous chemicals, who should take into account the fire, health and chemical hazard data given on this sheet. Store in closed vessels. Storage: Section 8. Exposure Controls / Personal protection Engineering Controls: Use only in a chemical fume hood. Personal protective equipment: Wear laboratory clothing, chemical-resistant gloves and safety goggles. General hydiene measures: Wash thoroughly after handling. Wash contaminated clothing before reuse. Section 9. Physical and chemical properties Appearance: Not specified Boiling point: No data No data Melting point: Flash point: No data Density: No data Molecular formula: C9H19N Molecular weight: 141.3 Section 10. Stability and reactivity Conditions to avoid: Heat, flames and sparks. Materials to avoid: Oxidizing agents. Possible hazardous combustion products: Carbon monoxide, nitrogen oxides. Section 11. Toxicological information No data. Section 12. Ecological information No data. Section 13. Disposal consideration Arrange disposal as special waste, by licensed disposal company, in consultation with local waste disposal authority, in accordance with national and regional regulations. Section 14. Transportation information Non-harzardous for air and ground transportation. Section 15. Regulatory information No chemicals in this material are subject to the reporting requirements of SARA Title III, Section 302, or have known CAS numbers that exceed the threshold reporting levels established by SARA Title III, Section 313.
A series of tryptophan-based selective nanomolar butyrylcholinesterase (BChE) inhibitors was designed and synthesized. Compounds were optimized in terms of potency, selectivity, and synthetic accessibility. The crystal structure of the inhibitor 18 in complex with BChE revealed the molecular basis for its low nanomolar inhibition (IC50 = 2.8 nM). The favourable in vitro results enabled a first-in-animal
Photoredox-Mediated Remote C(sp<sup>3</sup>)–H Heteroarylation of <i>N</i>-Alkyl Sulfonamides
作者:Zhiqiang Deng、Guo-Xing Li、Gang He、Gong Chen
DOI:10.1021/acs.joc.9b02502
日期:2019.12.20
heteroarylation of sulfonyl-protected primary aliphaticamines with N-heteroarenes under photoredox-catalyzed conditions was developed. The reaction typically uses a slight excess of amine reactant. The use of benziodoxole acetate (BI-OAc) oxidant and hexafluoroisopropanol solvent is critical to achieve high yield. Besides methylene C-H bonds, heteroarylation reactions of δ methyl C-H bonds also worked under
A compound of the formula
1
wherein R
1
, R
2
and R
3
are as defined above, which are inhibitors of the enzyme protein tyrosine kinases such as Janus Kinase 3 and as such are useful therapy as immunosuppressive agents for organ transplants, lupus, multiple sclerosis, rheumatoid arthritis, psoriasis, Type I diabetes and complications from diabetes, cancer, asthma, atopic dermatitis, autoimmune thyroid disorders, ulcerative colitis, Crohn's disease, Alzheimer's disease, Leukemia and other autoimmune diseases.
Design, synthesis, and biological evaluation of novel imidazo[
<i>1,2‐a</i>
]pyridinecarboxamides as potent anti‐tuberculosis agents
作者:Oluseye K. Onajole、Shichun Lun、Young Ju Yun、Damkam Y. Langue、Michelle Jaskula‐Dybka、Adrian Flores、Eriel Frazier、Ashle C. Scurry、Ambernice Zavala、Karen R. Arreola、Bryce Pierzchalski、A. Jean‐Luc Ayitou、William R. Bishai
DOI:10.1111/cbdd.13739
日期:2020.12
Tuberculosis (TB) is a highly infectious disease that has been plaguing the human race for centuries. The emergence of multidrug‐resistant strains of TB has been detrimental to the fight against tuberculosis with very few safe therapeutic options available. As part of an ongoing effort to identify potent anti‐tuberculosis agents, we synthesized and screened a series of novel imidazo[1,2‐a ]pyridinecarboxamide
The present application is directed to novel P2X7R antagonists that are indol-3-carboxamide or azaindole-3-carboxamide compounds, pharmaceutical compositions comprising the same and their use for the prophylactic or therapeutic treatment of diseases mediated by P2X7R activity.