摩熵化学
数据库官网
小程序
打开微信扫一扫
首页 分子通 化学资讯 化学百科 反应查询 关于我们
请输入关键词

tripropylstibine | 5613-69-4

中文名称
——
中文别名
——
英文名称
tripropylstibine
英文别名
Tripropyl-stibin;Tri-(n-propyl)-stibin;tripropylantimony;Tripropylantimon
tripropylstibine化学式
CAS
5613-69-4
化学式
C9H21Sb
mdl
——
分子量
251.016
InChiKey
FECHVIJLJQUVMZ-UHFFFAOYSA-N
BEILSTEIN
——
EINECS
——
  • 物化性质
  • 计算性质
  • ADMET
  • 安全信息
  • SDS
  • 制备方法与用途
  • 上下游信息
  • 反应信息
  • 文献信息
  • 表征谱图
  • 同类化合物
  • 相关功能分类
  • 相关结构分类

物化性质

  • 沸点:
    113 °C
  • 密度:
    1.241 g/cm3(Temp: 25 °C)

计算性质

  • 辛醇/水分配系数(LogP):
    3.71
  • 重原子数:
    10
  • 可旋转键数:
    6
  • 环数:
    0.0
  • sp3杂化的碳原子比例:
    1.0
  • 拓扑面积:
    0
  • 氢给体数:
    0
  • 氢受体数:
    0

反应信息

  • 作为反应物:
    描述:
    tripropylstibine 在 Na 、 water 、 SO2Cl2 作用下, 以 乙醚二氯甲烷 为溶剂, 生成 Dipropyl-antimomtrichlorid
    参考文献:
    名称:
    Gmelin Handbuch der Anorganischen Chemie, Gmelin Handbook: Sb: Org.Comp.2, 1.2.2.1.1, page 74 - 77
    摘要:
    DOI:
  • 作为产物:
    描述:
    参考文献:
    名称:
    Sacharkin; Ochlobystin, Izvestiya Akademii Nauk SSSR, Seriya Khimicheskaya, 1959, p. 1942,1946;engl.Ausg.S.1853,1856
    摘要:
    DOI:
点击查看最新优质反应信息

文献信息

  • Trinuclear complexes from the reactions of [Fe3(Co)12] with group VA ligands
    作者:Seamus M. Grant、A.R. Manning
    DOI:10.1016/s0020-1693(00)94978-8
    日期:1978.1
    AsIII and SbIII ligands, L1 with [Fe3(CO)12] under mild conditions give [Fe3CO11(L)], [Fe3CO10(L)2], and [Fe3(CO)9P(OR)3}3] derivatives as well as the mono- nuclear [Fe(CO)4(L)] and [Fe(CO)32] complexes. Cluster breakdown is greatest with phosphines and least with phosphites. Of the compounds thus obtained, only [Fe3(CO)9 P(OR)33}3] (R = iPr, cyclo-C6H11 and, perhaps, Et, o-MeC64 and p-MeC6H4) exist solely
    各种p III,As III和Sb III配体L 1与[Fe 3(CO)12 ]在温和条件下的反应得到[Fe 3 CO 11(L)],[Fe 3 CO 10(L)2 ],和[Fe 3(CO)9 P(OR)3 } 3 ]衍生物以及单核[Fe(CO)4(L)]和[Fe(CO)3 2 ]配合物。膦类的团簇分解最大,而亚磷酸盐的团簇分解最少。在如此获得的化合物中,只有[Fe 3(CO)9 P(OR)3 3 } 3 ](R = i Pr,环-C 6 H 11,也许还有Et,o -MeC 6 4和p -MeC 6 H 4)仅作为非桥联异构体存在于固态以及溶液中。其余为固态的CO桥连物种,其结构可能基于[Fe 3(CO)12]的CO桥连形式。]。在溶液中,它们异构化为CO桥联异构体与其他不具有桥联配体的混合物。后者占主导地位。非桥接互变异构体的红外光谱不能得出关于其结构的任何结论。
  • The synthesis and infrared spectra of some group Va chalcogenides
    作者:George N. Chremos、Ralph A. Zingaro
    DOI:10.1016/s0022-328x(00)87720-7
    日期:1970.5
    The trialkylstibine oxides, a poorly understood group of compounds, have now been unequivocally characterized. The fundamental stretching frequencies v(SbO), v(SbS), v(SbSe) and v(PTe) have been assigned in a series of compounds, R3MX where M is a P or Sb atom and X is O, S or Se.
    三烷基二氧化锡,一类化合物,人们了解得很少,现在已经被明确地表征了。基本振动频率v(SbO),v(SbS),v(SbSe)和v(PTe)已在一个系列的化合物,被分配- [R 3 MX其中M是P或Sb原子,X为O,S或Se。
  • Conformal Properties of InSbTe Thin Films Grown at a Low Temperature by MOCVD for PRAM Applications
    作者:Jun-Ku Ahn、Hyun-Jin Cho、Kyoung-Woo Park、Soon-Gil Yoon
    DOI:10.1149/1.3363618
    日期:——
    The feasibility of InSbTe chalcogenide materials prepared by metallorganic chemical vapor deposition (MOCVD) for phase-change memory (PRAM) applications was demonstrated. Films grown below 225°C exhibited an amorphous structure, and the films grown at 300°C included various crystalline phases such as In-Sb-Te, In―Sb, In-Te, and Sb-Te. The composition of the amorphous films grown at 225°C was dependent
    证明了通过金属有机化学气相沉积 (MOCVD) 制备的 InSbTe 硫属化物材料用于相变存储器 (PRAM) 应用的可行性。在 225°C 以下生长的薄膜呈现出非晶结构,而在 300°C 下生长的薄膜包括各种晶相,例如 In-Sb-Te、In-Sb、In-Te 和 Sb-Te。在 225°C 生长的非晶薄膜的成分取决于工作压力。225℃下生长的薄膜形态光滑,均方根粗糙度小于1 nm,在纵横比为5:1的沟槽结构上生长的薄膜阶梯覆盖率大于90%。沉积时间的增加提高了填充率,同时保持了共形阶梯覆盖。
  • First structural characterization of completely alkyl-substituted Al–Sb Lewis acid–base adducts
    作者:Stephan Schulz、Andreas Kuczkowski、Martin Nieger
    DOI:10.1016/s0022-328x(00)00240-0
    日期:2000.6
    acid–base adducts R3Al←SbR′3 (R′=Et, R=Me (1), Et (2), t-Bu (3); R′=n-Pr, R=Me (4), Et (5), t-Bu (6); R′=i-Pr, R=Me (7), Et (8), t-Bu (9); R′=sec-Bu, R=Me (10), Et (11), t-Bu (12); R′=t-Bu, R=Me (13), Et (14), t-Bu (15)) were obtained by reaction of aluminum trialkyls R3Al and the corresponding antimony trialkyls R′3Sb. For the first time, solid state structures of all-alkyl substituted Al–Sb adducts (3,
    几个路易斯酸-碱加合物- [R 3的Al←SBR' 3(R'=的Et,R =我(1),等(2),吨-Bu(3); R'= Ñ -Pr,R =我(4),Et(5),t -Bu(6); R'= i -Pr,R = Me(7),Et(8),t -Bu(9); R'= sec -Bu,R = Me (10),Et(11),t -Bu(12); R'= t -Bu,R = Me(13),Et(14),吨-Bu(15))通过三烷基铝的反应得到[R 3 Al和相应的三烷基锑R' 3的Sb。首次,全烷基的固态结构的被取代的Al-Sb的加合物(3,9,13,14)通过单晶X-射线分析测定。
  • Synthesis and structural characterization of the first completely alkyl-substituted Ga–Sb Lewis acid–base adducts †
    作者:Stephan Schulz、Martin Nieger
    DOI:10.1039/a908969a
    日期:——
    The simple Lewis acid–base adducts (n-Bu)3Ga(SbR3) (R = Et 1, n-Pr 2, i-Pr 3, t-Bu 4) and (t-Bu)3Ga(SbR3) (R = Et 5, n-Pr 6, i-Pr 7, t-Bu 8) were prepared by combination of n-Bu3Ga or t-Bu3Ga, respectively, with the corresponding trialkylstibanes in a 1∶1 molar ratio. 1–8 were fully characterized by multinuclear NMR (1H and 13C) and mass spectroscopy. In addition, the solid state structures of 5 and 7 were determined by single crystal X-ray diffraction studies.
    简单的路易斯酸碱加合物(n-Bu)3Ga(SbR3)(R = Et 1,n-Pr 2,i-Pr 3,t-Bu 4)和(t-Bu)3Ga(SbR3)(R = Et 5,n-Pr 6,i-Pr 7,t-Bu 8)是通过将n-Bu3Ga或t-Bu3Ga分别与相应的三烷基胂在1:1摩尔比下结合制备的。1至8均通过多核NMR(1H和13C)和质谱进行了全面表征。此外,通过单晶X射线衍射研究确定了5和7的固态结构。
查看更多